Six Die System
1:Support System
In forming the larger products,due to the two-mode foot span between the larger,at a high injection pressure,public template bending deformation may occur,resulting in forming defects,to solve this problem,there was a need to increase support things are common:
A.Mold feet B.supporting column (SP)
2:Prototyping System
For molding,common are:
A,the public and the mother die Ren B,slider C,oblique pin D,into the sub -
3:Guiding System
To be top of the balance,the smooth mold,usually using some of the things-oriented positioning.Common are:
1.Introduction column (public-oriented,the mother templates) 2.Roof Guides (Ejection-oriented board) 3.Positioning block 4.RP
4:Top of the system
A.Top of the top-selling B.block C.sleeve D.stripping plate E.Gas Ejection
5:Gating System
Injection molding machine nozzle in the molten plastic,through the mainstream Road,shunt,and finally through the gate into the mold cavity,and then after cooling solidification,get the finished product.Gating system is therefore mainly includes the following three:
A.mainstream Road B.shunt gate C.
6:Temperature Control System